To reconfigure the switch, the technician needs to click on the appropriate port(s) on Switch 1 and Switch 3. The technician should ensure that each device only has access to its correctly associated network. The technician should also disable all unused switch ports. Finally, the technician should require fault-tolerant connections between the switches. If at any time the technician wants to bring back the initial state of the simulation, they can click on the Reset All button.

Tagged = Switch to Switch connections.
Untagged = Devices (WLAN, Servers, Printers, VoIP)
Port Enabled = if there is a device connected
Port Disabled = if there is nothing connected on the port.

Switch Diagram

Switch Configuration Simulation

Switch 1
Port Status LACP Speed Duplex VLAN Configuration
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
Port 8
Switch 3
Port Status LACP Speed Duplex VLAN Configuration
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7
Port 8